FreeCAD Forum

Hello,

is it possible to change the line width in the sketcher mode?
I know i can change the line width point size and so on when i close the sketch.
But is it possible direct in sketch mode?
Another question i work in my companiy with SolidEdge there is this cool snapping mode in Sketch Mode. It similar to Autocad but with contrains.
Would it possible to implement the Snapping Tools from the Draft Workbench in the Sktecher Workbench?

Thanks

best regards

It may be possible but AFAIK there are no such plans. The approach is a different one, in sketcher you apply the constraints, and currently there are different means to achieve something similar, namely using AutoConstraints or the Polyline tool with its M key for different continuation modes.

okay thanks