Page 1 of 1

Fusing lines in a sketch

Posted: Wed Jan 01, 2020 11:37 pm
by malavB
Hello,

I am developing a 3D model by revolving a sketch. The points present in the sketch generates additional edges in the 3D model. Is there any way to fuse the edges of a sketch to avoid additional edges?

Find the Sketch and model snaps below:

Sketch
https://imgur.com/5gciXFz

Body
https://imgur.com/ooygDWn

Malav

Re: Fusing lines in a sketch

Posted: Thu Jan 02, 2020 12:19 am
by chrisb
What's the problem with these edges? You can suppress additional edges on plane or on cylindrcal faces with the refine property. The edges in your model are substantial, and can be suppressed only if you model the whole curve in one B-spline.