Elmers Wooden beam engine

Show off your FreeCAD projects here!
Post Reply
un1corn
Posts: 149
Joined: Sat Dec 26, 2015 2:06 pm

Elmers Wooden beam engine

Post by un1corn » Fri Jan 10, 2020 9:17 am

This was done on FC V0.16 in November 2017. only took a couple of days.
The plans are by JDW Draughting services NZ and can be found here:- http://www.vapeuretmodelesavapeur.com/telechargements5/
Attachments
WB 1.JPG
WB 1.JPG (96.02 KiB) Viewed 1164 times
WB 2.JPG
WB 2.JPG (86.39 KiB) Viewed 1164 times
WB 3.JPG
WB 3.JPG (48.8 KiB) Viewed 1164 times
WB 6.JPG
WB 6.JPG (184.28 KiB) Viewed 1164 times
fmluizao
Posts: 44
Joined: Tue Nov 19, 2019 7:16 pm

Re: Elmers Wooden beam engine

Post by fmluizao » Fri Jan 10, 2020 3:11 pm

Amazing :o

Do you mind to share the model? How did you assembly?
un1corn
Posts: 149
Joined: Sat Dec 26, 2015 2:06 pm

Re: Elmers Wooden beam engine

Post by un1corn » Sat Jan 11, 2020 1:09 pm

The file of parts for this model is 6MB and so unable to post here, I used Assembly 2 in FC V0.16 and worked from the base up, after having created subassemblies of the Moving, con-rod and valve beams and also the crankshaft.
fmluizao
Posts: 44
Joined: Tue Nov 19, 2019 7:16 pm

Re: Elmers Wooden beam engine

Post by fmluizao » Mon Jan 13, 2020 11:44 am

un1corn wrote:
Sat Jan 11, 2020 1:09 pm
The file of parts for this model is 6MB and so unable to post here
No problem. Just curious about how you designed the parts. Did you used PartDesign or Part WB?
un1corn
Posts: 149
Joined: Sat Dec 26, 2015 2:06 pm

Re: Elmers Wooden beam engine

Post by un1corn » Mon Jan 13, 2020 3:12 pm

The parts were created in Part Design WB with the occasional use of Part WB for primitives, sweep and loft etc. where necessary.
triplus
Posts: 9136
Joined: Mon Dec 12, 2011 4:45 pm

Re: Elmers Wooden beam engine

Post by triplus » Wed Jan 15, 2020 7:19 pm

Looking good.
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests