Elmers Wooden beam engine

un1corn · Post by **un1corn** » Fri Jan 10, 2020 9:17 am

This was done on FC V0.16 in November 2017. only took a couple of days.
The plans are by JDW Draughting services NZ and can be found here:- http://www.vapeuretmodelesavapeur.com/telechargements5/

fmluizao · Post by **fmluizao** » Fri Jan 10, 2020 3:11 pm

Amazing

Do you mind to share the model? How did you assembly?

un1corn · Post by **un1corn** » Sat Jan 11, 2020 1:09 pm

The file of parts for this model is 6MB and so unable to post here, I used Assembly 2 in FC V0.16 and worked from the base up, after having created subassemblies of the Moving, con-rod and valve beams and also the crankshaft.

fmluizao · Post by **fmluizao** » Mon Jan 13, 2020 11:44 am

un1corn wrote: ↑Sat Jan 11, 2020 1:09 pm The file of parts for this model is 6MB and so unable to post here

No problem. Just curious about how you designed the parts. Did you used PartDesign or Part WB?

un1corn · Post by **un1corn** » Mon Jan 13, 2020 3:12 pm

The parts were created in Part Design WB with the occasional use of Part WB for primitives, sweep and loft etc. where necessary.

triplus · Post by **triplus** » Wed Jan 15, 2020 7:19 pm

Looking good.

Elmers Wooden beam engine

Elmers Wooden beam engine

Re: Elmers Wooden beam engine

Re: Elmers Wooden beam engine

Re: Elmers Wooden beam engine

Re: Elmers Wooden beam engine

Re: Elmers Wooden beam engine