This was done on FC V0.16 in November 2017. only took a couple of days.
The plans are by JDW Draughting services NZ and can be found here:- http://www.vapeuretmodelesavapeur.com/telechargements5/
Elmers Wooden beam engine
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Elmers Wooden beam engine
- Attachments
-
- WB 1.JPG (96.02 KiB) Viewed 2623 times
-
- WB 2.JPG (86.39 KiB) Viewed 2623 times
-
- WB 3.JPG (48.8 KiB) Viewed 2623 times
-
- WB 6.JPG (184.28 KiB) Viewed 2623 times
Re: Elmers Wooden beam engine
Amazing
Do you mind to share the model? How did you assembly?
Do you mind to share the model? How did you assembly?
Re: Elmers Wooden beam engine
The file of parts for this model is 6MB and so unable to post here, I used Assembly 2 in FC V0.16 and worked from the base up, after having created subassemblies of the Moving, con-rod and valve beams and also the crankshaft.
Re: Elmers Wooden beam engine
The parts were created in Part Design WB with the occasional use of Part WB for primitives, sweep and loft etc. where necessary.
Re: Elmers Wooden beam engine
Looking good.