Line thickness and points too big

[paddle]

Hi there!
I have been trying to make a drawing of a part, but I can't get correct line thickness and there're big points showing up everywere.

techdraw2.png (70.14 KiB) Viewed 3330 times

I then tried to select custom scaling and aplied a 5:1 scaling but the points and line still seem too big.

techdraw.png (311.22 KiB) Viewed 3330 times

Note: the body I'm trying to draft is one of a much bigger assembly. So I wonder if it's not because the drafting takes automatically set the line/point dimensions according to the whole object?

techdraw3..png (27.93 KiB) Viewed 3330 times

Is there a way to modify the line thickness and points radius?
Thanks!

I'm using v0.19, though the part has been made on 0.18.

[ingussp]

Press button which i show on picture

[chrisb]

If the points are too big during editing, e.g. obscuring center marks: Preferences->TechDraw->VertexScale
LineWidth can be changed in the View attributes of each view in the secction Lines, or globally in Preferences->TechDraw->Annotation->LineWidthGroup.

[paddle]

Thanks !