sheet metal

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
TAS
Posts: 7
Joined: Fri Nov 08, 2019 2:55 pm

sheet metal

Post by TAS »

windows 19. sheet metal unfold caused the model to be totally destroyed. sketches and creation became unknown titled. they were frozen loosing the connection to the sketch. can individually unfold bends but can not have a hole etc. on the surface. when back to 18 and it unfolded but did so after trying 19. Finally made a separate model copy to unfold because it would be not parametric again. lost all features like holes put into the folded model surfaces. they had to be put at the end after all folds done and then deleted on the fold model before unfolding by any method.
How do you use fold lines. No tutor I could find or directions that showed how to pick a line(s) for the fold. Likely stamping also is not explained.
User avatar
-alex-
Veteran
Posts: 1856
Joined: Wed Feb 13, 2019 9:42 pm
Location: France

Re: sheet metal

Post by -alex- »

Please send your FreeCAD information http://forum.freecadweb.org/viewtopic.php?f=3&t=2264
Could you send some file?
Post Reply