Boolean-Fragments as Boolean operation in PDN

[chrisb]

I don't see at the moment the benefit of switching workbenches. Why don't you model the complete nut in one body?

[user1234]

This is the problem, CompSolids are not available in the PartDesign Workbench. So i have to swich to the Part Worckbench (and mix it). And the Parts i make are much easier to construct in PartDesign (mechanical engineering).

Greetings
user1234

[NormandC]

It's simple: PartDesign does not support multiple solids. There is nobody willing to work on this. It might take a long time (years possibly) before that changes.

Here are some explanations on the subject, you'll need to use a translation service to translate it from German. https://forum.freecadweb.org/viewtopic. ... 40#p198094