Selection problems with sketcher

Post here for help on using FreeCAD's graphical user interface (GUI).
User avatar
fosselius
Posts: 81
Joined: Sat Apr 23, 2016 10:03 am

Selection problems with sketcher

Postby fosselius » Fri Jun 15, 2018 6:22 am

I have lately gotten issues with the sketcher, it have become hard/impossible to select vertices, edges and constraints.
Are building from source. Is this an known issue?
chrisb
Posts: 8406
Joined: Tue Mar 17, 2015 9:14 am

Re: Selection problems with sketcher

Postby chrisb » Fri Jun 15, 2018 6:44 am

fosselius wrote:
Fri Jun 15, 2018 6:22 am
I have lately gotten issues with the sketcher, it have become hard/impossible to select vertices, edges and constraints.
Are building from source. Is this an known issue?
Which system do you use? There were issues when the grid in sketcher was turned on, but they have been fixed in master.
- I know the described behaviour when I have turned the sketch by 180° and edit it from behind.
- On the Mac I often have problems selecting constraints, but never points or edges.
User avatar
fosselius
Posts: 81
Joined: Sat Apr 23, 2016 10:03 am

Re: Selection problems with sketcher

Postby fosselius » Fri Jun 15, 2018 12:29 pm

removed my .FreeCAD folder and made a clean then configure and make, problem is gone now.
User avatar
NormandC
Posts: 15531
Joined: Sat Feb 06, 2010 9:52 pm
Location: Québec, Canada

Re: Selection problems with sketcher

Postby NormandC » Fri Jun 15, 2018 4:45 pm

This is an end user issue, regarding the sketcher.

Why post in the PartDesign module development forum? (PartDesign, not Sketcher) Do you not know what "development" in the title implies? Have you not noticed the description for the forum in the Forum index?

About the development of the Part Design module/workbench. PLEASE DO NOT POST HELP REQUESTS HERE!
Geez! How hard can it be?