I am using V19 and following the nstructions to put a placeholder. But a grid seems to cover the face and then I can't select it. I turn the gid off, save and exit. Then run a fresh copy. But there is the grid again. Is the grid covering the face or is there some other reason I ca't get the External geometry tool to find the corner of the face.
I admit I had problems messing around ealier and not arrive at this point by a direct tutorial path.
One other question. How to cut and paste just a fully constrained sketch from one place to another. When I cut, am just getting the 2D sketch or do axes come with it. Some sketches are complicated and I would like to reuse them or move them to where they should have been in the first place.
I often goof and end up in corners where it is difficult to get out! My usual fix is exit FC completely saving. Then start with clean code and file.
Note also that I can't use Create planar image with my Radeon Sapphire Radeon R9 270X 4GB PCI-E video card after updating all drivers this am. Get protection violation. It is a known issue??
Thanks for any help.