Hi everyone !
I have just report some bugs in mantis tracker about windows. issue #1835 issue #1834
But there is a last one but not clear.
Just make 4 walls like a rectangular house. (y=5,x=10m)
Select the face of wall that is toward Y direction.
Set it as working plane
Try to make a window on the recently selected face, with passive snap mode,
The window is reverse relative to Z (like issue #1604
Can you reproduce ?
Finnaly a feature request/open discussion about that :
I found task panel more friendly that the swith to sketch WB.
I found that placing windows with plane reference is usefull.
But I found that we can not have snap to point and plane together.
So I think that : active the task panel by default, with or without selected face.
In task mode, if a face is selected,
The preseted window is forced to the plane of the face.
So we can use just snap-point to set placement
Could work perfectly with sill height (sill height forced the Z position, plane is forced by face selected). We could add window in top view mode. Well it still the face selection, but for a long wall, that could be usefull with continue mode
The task panel get a button to enter sketch edit mode.
If no face, a window is create without support (mapped later).